Overview
The PDX Elite Moto Milker by Pipedream is an automatic stroking masturbator designed to deliver hands-free stimulation through a combination of motorised thrusting and targeted vibration. The device surrounds the shaft with an ultra-soft TPE sleeve fitted with round nubbies, while the internal motor drives continuous up-and-down stroking motion. With separate controls for thrust and vibration, the Moto Milker gives you full command over your experience without any manual effort required.
Key Features
- Intermittent suction technology powered by an ultra-strong motor for deep, automatic stroking
- 10 thrusting modes that stroke the penis up and down without any manual input
- 10 vibration modes delivered by a strategically positioned vibrator for shaft stimulation
- Ultra-soft TPE sleeve lined with round nubbies that wrap around the entire shaft
- Removable sleeve with magnetic contacts for straightforward disassembly and cleaning
- USB rechargeable via included charging cord
- Pause function accessible via the power button — press once to pause all modes, press again to resume
Specs at a Glance
12.7 cm
Insertable Length
8.9 cm
Overall Width
10 + 10
Thrust + Vibration Modes
USB Rechargeable
Power Source
Specifications
- Brand: Pipedream
- Range: PDX Elite
- Type: Automatic Stroking Masturbator
- Sleeve Material: TPE
- Insertable Length: 12.7 cm
- Overall Width: 8.9 cm
- Thrusting Modes: 10
- Vibration Modes: 10
- Power: USB rechargeable (charging cord included)
- Sleeve Attachment: Magnetic contacts
- Lubricant Compatibility: Water-based lubricant recommended (e.g. Wicked Aqua)
- Waterproofing: Not submersible — do not submerge device in water
Quick Start Guide
- Press and hold the power button for 3 seconds to turn the device on — it will start in stand-by mode
- Press the thrust button to activate thrusting and cycle through all 10 thrusting modes
- Press the vibration button to activate vibration and cycle through all 10 vibration modes
- Press the power button once to pause all thrusting and vibration (all 3 buttons will blink); press again to resume
- Press and hold the power button for 3 seconds to turn the device off
Care Instructions
The TPE sleeve is removable — gently pull the edges to detach it from the cylinder before cleaning. Wash the sleeve with antibacterial cleaner and warm water, then allow it to dry thoroughly. Use a damp cloth to wipe down the outer casing of the device. Do not submerge the Moto Milker in water at any time.
To detach the sleeve, pull it free and disconnect the magnetic contacts. When re-inserting, align the vibrating bullet with the notch on the cylinder and push the sleeve in until the magnetic contacts click into place. The vibration function will only operate correctly when these contact points are properly aligned.
What's Included
- PDX Elite Moto Milker device
- USB charging cord
